Beef ribs on the Weber Summit Kamado

  • Some of the links on this forum allow SMF, at no cost to you, to earn a small commission when you click through and make a purchase. Let me know if you have any questions about this.
SmokingMeatForums.com is reader supported and as an Amazon Associate, we may earn commissions from qualifying purchases.

Oldguy68

Fire Starter
Original poster
Sep 15, 2023
56
61
Cape Cod, MA
Hello kettleheads,
I did some beef ribs this past Sunday on the Weber Summit.
Used pepper, Lawry's seasoned salt and a few crushed beef bouillon cubes as a rub.
I did not remove the silver skin. I just scored them in a checker pattern with a knife.
Smoked with some post oak chunks and used Frontier brand lump charcoal.
Temps with the Slow 'N Sear in were higher than I would have liked at 275-300 degrees.
That was with lower damper all the way closed. It was a little breazy and wet out.
Upper damper was open about 1/4 inch.
About six or seven hours in I wrapped them at 185 degrees and took them out at around 205 degrees.
Came out great, but a little salty. Lighter on the Lawry's next time.
Happy smoking everyone! Pete
IMG_3894.jpg
IMG_3898.jpg
IMG_3899.jpg
 
Last edited:
Nice color and hillbilly teeth on those ribs. I bet they were good. I haven't removed the silver skin in years. I think they stay a little moister that way. Nice job OldGuy

Point for sure
Chris
 
  • Like
Reactions: Oldguy68
SmokingMeatForums.com is reader supported and as an Amazon Associate, we may earn commissions from qualifying purchases.
Great deal on LEM Grinders!

Latest posts

Hot Threads

Clicky