Beef Rib Rack Today

  • Some of the links on this forum allow SMF, at no cost to you, to earn a small commission when you click through and make a purchase. Let me know if you have any questions about this.
SmokingMeatForums.com is reader supported and as an Amazon Associate, we may earn commissions from qualifying purchases.

dubob

Meat Mopper
Original poster
Mar 1, 2019
281
166
Mormon Mecca
Windy & cold, so no fishing going on today. Good day to try cooking some beef ribs. Started by opening the rack cryovac bag and separating the rack into 2-bone sections. That gave me 4 sections. Salted them down last night, covered them with plastic wrap, and refrigerated overnight. This morning I applied a good coating of Treager's Beef Rub and then prep'd the grill to 225*F. I also filled my LANNEY 12'' Stainless Steel BBQ Wood Pellet Tube Smoker for Cold/Hot Smoking and lit it - first time using an additional smoke source. I then sprayed my frog mats with PAM and placed them on the raised grill section of my pellet pooper. When the grill reached 225*F, I put the 4 sections of ribs on the mats and inserted 2 temp probes (Inkbird-IRF-4S) and set alarm for 203*F.
trMZcJ9.jpg


Ea1QiFy.jpg


It took about 4 1/2 hours to get to 203*F which is about right according to the recipe I used. They were cooked naked the whole time. When I pulled them, I let them rest for about 10 minutes before eating 3 ribs for lunch. My bride had another one and here is what is left.

Jb0V6sJ.jpg


They look a little dark, but you'll have to trust me when I say they were absolutely D E L I C O U S to eat. We did not put any sauce on them and they were VERY good without any sauce.

I think the darker bark came from letting them sit in the grill for about 15 minutes after the temp alarm went off because we were watching a good movie and it had about that long to go to the end. Next time, I'll put the movie on pause and pull the cook immediately. Lessen learned. Didn't harm the taste at all, but could have looked better.

Also, now that I have a full rib rack under my belt, I think I'll look for individual ribs that have a little more meat on top of the bones. Both the racks I bought have less than a full inch of meat on top. I think 1 1/2 to 2 inches of meat on top would be better; don't you?

Later this week, I'm going to try some of Mr Mixon's Bacon Wrapped Coca Cola Chicken Breasts.

Life is GOOD! :D
 
Looking tasty!
Mmmm, Mmmm yummy!
Beef ribs have so much flavor, even the Back Ribs/Shiners.



Hell yeah more... More, more, more, the thicker and meatier the better.
Now I hate to burst your bubble but you still haven't done a rack if you consider cooking these 2 bone sections.
Ya gotta cook the whole rack as a whole.
But that's just a technicality, few of us have ever cooked a WHOLE rack of beef ribs cause our grill just aren't big enough.... LOL :emoji_stuck_out_tongue_winking_eye:

Go forth and find ya some nice racks of Chuck, Short Ribs or even better Plate, Short Ribs.
The Chucks shown below are BIG, but the Plates (not shown) are HUGE!




My method for these is located here.
https://www.smokingmeatforums.com/t...o-more-teasing-time-to-start-pleasing.277097/
 
  • Like
Reactions: motolife313
Chili,

Those ribs look absolutely – dare I say it on here – ‘Amazing’. :emoji_wink: Neither of the two racks I bought have anywhere near that amount of meat. I still have one left in the freezer.

The Smoked Texas-Style BBQ Beef Ribs Recipe (by Meathead) I used called for separating them into 2 rib sections, so that’s what I did. I will do the remaining rack as a full rack – probably over Memorial Day Weekend.

Life is GOOD!
 
SmokingMeatForums.com is reader supported and as an Amazon Associate, we may earn commissions from qualifying purchases.
Clicky