• Some of the links on this forum allow SMF, at no cost to you, to earn a small commission when you click through and make a purchase. Let me know if you have any questions about this.

knives

  1. T

    issues with BIG hobart 4246hd and 4346 mixer grinders

    I've been tasked with getting these machines up and running after some parts were removed, they use #32 plates and knives. The issue is the studs on the auger tips- one machine is 1/2" and the other is just a little over 7/16". I see most plates have 1/2" center stud holes which actually...
  2. SonnyE

    Liking a good blade...

    Seemed to me this was the right spot to talk KNIVES... I was raised to love a good edge for the work at hand. Dad always loved his pocket knife razor sharp. Our hunting and fishing sheath knives would cut to the bone with little effort. So, I kind of look at the metallurgy as well as the...
Top Bottom
AdBlock Detected

We get it, advertisements are annoying! (But that's how we keep the lights on.)

We noticed that you're using an ad-blocker, which could block some critical website features. For the best possible site experience please take a moment to disable your AdBlocker.

I've Disabled AdBlock
No Thanks