Search results for query: *

Basically have it done. Just need to get the table stained and varnished. Also found out how fragile the temp gauges are and have to replace those. The forums were a huge help in getting this finished and putting out some meat. Thanks to all those that helped out along the way!

Getting closer to the finish line. Did the plenum and then reworked it because I didn’t like it but I think it’s where it needs to be and I like the looks of it. The exhaust is 6” diameter pipe. Added a vertical handle to the side air vents to the firebox and got that all welded in place. Had...

Made a little more progress. Got the RF plate in and the opening cut for the FB going into the CC. I have a couple of questions to pose to the group. The smoker is going to be mounted on a trailer. Is there a place where a guy can go and get information about the correct weight and placement...

Been able to make a little progress over the past several days. Still wrangling to get the reverse flow plate in. Probably have to cut one side off to get it in there and then weld it back together. Found some really sturdy hinges out of a truck I plan to use on the doors.

Thanks Dave I will try that

In my previous post concerning the ESV I stated the 0.022 could not be reached w/a stack hight of 36", but 36 could be achieved by using 0.025, I should have said 0.02050, I am curious if that is sufficient, help me here if anyone has a thought on this, Thanks a lot.

49,212cu."the CC/RFP opening is 197SQ "and the area under the RFP and the area at the end of the RFP.is the same, My required or min.Cu." of the fire box is 16,240- my box is 23,040, as you can see it is actually quiet lg, I'm thinking of some fire brick.the ESV. That I am using is 6" ID and at...

The tank I have is a 220 gal propane tank.I have used the tutorial here and have the following calcs. And info., it would be very helpful if you guys could ck my info, and give me some feedback The CC IS 29.5X72 ID.THAT IS

This is my first build and any help and advice is appreciated. Already have the doors cut and my next post will have my calculations if one of you all can check them for me. Looking forward to the build and any helpful advice you all have.