Search results

  • Some of the links on this forum allow SMF, at no cost to you, to earn a small commission when you click through and make a purchase. Let me know if you have any questions about this.
  1. FZR650

    I build and make stuff. Knives, swords, BBQs, Smokers, blacksmithing, forging just to name a few.

    I build and make stuff. Knives, swords, BBQs, Smokers, blacksmithing, forging just to name a few.
    • FZR650
    • Profile post
  2. FZR650

    My eletric smoker

    I built this beast in the fall. I have used it twice (smoke salmon with scallop were perfect - the brisket was a fail do to heat problems) 36” tall x 24” wide x 18” deep. {I’m looking into kiln wire element connected to a PID unit for heat. Commercial smoker use kiln elements} The smoke is from...
  3. FZR650

    Gotta heating element question. Help needed.

    Thanks for the info, but you’re missing information too. My smoker heating element reached 237 degrees within 1 hr, the next day it would not reach above 134 degrees with in 6 hrs no matter where the dial was set at. As for now I know that my setup can get up to 237, but with the dial thermostat...
  4. FZR650

    Gotta heating element question. Help needed.

    About 3 weeks ago I finished building my electric smoker. 36” high x 24” wide x 18” deep. The heating element I bought from amazon, it’s a 1500 watt with dial thermostat control of low, medium, high with a temp range of 50-450 degrees. I built this smoker for low and slow smoking as I also built...
Top Bottom
Back
Clicky