Search results
-
Some of the links on this forum allow SMF, at no cost to you, to earn a small commission when you click through and make a purchase. Let me know if you have any questions about this.
-
Temperature issues Please Help
What's the btu rating? You may have a bad regulator , certainly should go over 150* Try to purge the regulator, do this by ; turn to high shut off tank and let flame burn out at this point Try again- imjesse1
- Post #2
- Forum: Propane Smokers
-
Blowing Smoke in Cbus, OH
I have a food saver, I like going to SAMs club and buying meat in bulk then freezing in smaller portions... My food saver works only 2-3 times and then it seals before it gets all the air out, I don't know what's wrong with it but I'm not buying a new one until it breaks once and for all -
Blowing Smoke in Cbus, OH
Wow that's crazy penzeys gets all the way out by you , I'm from the Milwaukee area and I used to work at there small warehouse , I thought it was just a mom n' pop joint with a few local stores.... There is a member on hear who said to try pulled pork pizza with leftovers, that is by far the... -
Blowing Smoke in Cbus, OH
- imjesse1
- Album
- Comments: 0
-
Where's all the SMF Bikers at?
- imjesse1
- Post #14
- Forum: General Discussion
-
Where's all the SMF Bikers at?
- imjesse1
- Album
- Comments: 0
-
Nevada Newbie
Make sure you post pictures of the jerky Welcome! Jesse~ -
Friday night Concoction
- imjesse1
- Album
- Comments: 0
-
-
temp control notifications???
Well the Mavrick is very loud it would wake me up from a dead sleep- imjesse1
- Post #9
- Forum: Slicers, Grinders, Tools, Equipment
-
temp control notifications???
Yes, your right... I guess it depends on how much $ you have and what other uses you would have for the maverick...- imjesse1
- Post #7
- Forum: Slicers, Grinders, Tools, Equipment
-
temp control notifications???
Your wanting email in case your not home ?? The 732 goes 300 feet plus you can use it for other things, I have 5 cookers I just don't think it's worth the extra $$- imjesse1
- Post #5
- Forum: Slicers, Grinders, Tools, Equipment
