Some of the links on this forum allow SMF, at no cost to you, to earn a small commission when you click through and make a purchase. Let me know if you have any questions about this.
You are using an out of date browser. It may not display this or other websites correctly. You should upgrade or use an alternative browser.
Hello everyone. Finally got to a point where my bbq is somewhat useable. When it's working it works great but occasionally it backfires and the flame goes from being in the slits inside to burning where the gas and air are mixing. Doesnt look the best yet since I'm still trying to figure out...
Ah I see, though it would be enough when it mixes coming out the orifice. The regulator I have now doesnt have air intake. I was a little worried that the pipe size would be to small. Will try it out with the proper air intake and if not good enough I will have to get bigger piping. Thank you sir.
Made a burner out of half in stainless tubing and drilled 1/16 in holes. Flame is coming out yellow how would I go about getting more oxygen to it?
Still need to drill more on middle tube.
Picture: https://ibb.co/SBqrW8D