Some of the links on this forum allow SMF, at no cost to you, to earn a small commission when you click through and make a purchase. Let me know if you have any questions about this.
Hey guys I'm building a food trailer and have installed a transfer switch, now I have my shore power figured out but for the generator...do you hard wire the generator right to the trailer or do you use a plug? Not sure if I can just use a plug in the wall then a little jumper cable or if it'll...
Hey guys when I cook a brisket my lean always seems to be too tough, but I go by when the point gets probe tender. Here are some pictures of each. I cook at about 275, wrapping in butcher paper after about 7 hours. Prime briskets. What am I doing wrong?
Josheaton, I would defiantly open that up a lot more. I personally cut mine as big as I could, but then again I'm using a 1,000 gallon tank and am trying to acquire as much air flow as possible. Which seems to work pretty good because I can keep the whole 16' of cooking chamber within 25 degrees...
Yeah possibly I run mine about half open. I get about a 25 degree difference front to back. Maybe 50 when I had 15 briskets first put in it, but it leveled out as the briskets started to warm up.
This is what I used:
https://www.amazon.com/gp/product/B0067NIY16/?tag=smokingmeatforums-20
Thank you everybody for the kind words. And it doesn't have to be a dream. Just a lot of time and patience. Was easy to build, just time consuming.
I wrap in foil after about 4 hours and then cook until super tender and then let it rest for at least an hour in the foil. Once rested I take it out of the juice (in pieces because it no longer stays together.) and pull it in a separate vessel. I once pulled it in the juice and people complained...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.