Recent content by ron d

Some of the links on this forum allow SMF, at no cost to you, to earn a small commission when you click through and make a purchase. Let me know if you have any questions about this.

low presure burners

ill have to get back with pics
- ron d
- Post #5
- Dec 4, 2013
- Forum: Roll Call
pics

whats the best way to down load pics? im not leterate on computers at all
- ron d
- Thread
- Dec 3, 2013
- Replies: 3
- Forum: Roll Call
low presure burners

thanks gary.what is your opinion on how to build a 40 ich long low presure burner what should i use
- ron d
- Post #3
- Dec 3, 2013
- Forum: Roll Call
low presure burners

i need three low presure burners 40 inches long, can it be done?
- ron d
- Thread
- Dec 3, 2013
- Replies: 6
- Forum: Roll Call
galvinise mistake

Thanks I have had it GLOWING RED. So im leaving them. Thanks for the help
- ron d
- Post #5
- Dec 1, 2013
- Forum: Blowing Smoke Around the Smoker.
galvinise mistake

i built a gas cooker out of a 60 gallon air compresor tank and its beautiful. my delema is that i inadvertaantly use two peaces of 2 inch square peaces of 1/16 inch plate galvinise in the bottom of it. it will be a huge job to get it out or i would have already. my question is is it so big a...
- ron d
- Thread
- Nov 30, 2013
- Replies: 5
- Forum: Blowing Smoke Around the Smoker.
new guy

hello all. new to SMF. I have built a couple of charcoal grills and a couple gas grills. i havent taken many pics because my camera is broken. ill work on it. I live in North Carolina.(from OK).but i love N Carolina. i can weld pretty good im ok in fab work but i def need some help on all...
- ron d
- Thread
- Nov 30, 2013
- Replies: 3
- Forum: Roll Call

Top Bottom

Back