-
Some of the links on this forum allow SMF, at no cost to you, to earn a small commission when you click through and make a purchase. Let me know if you have any questions about this.
Recent content by OPri
-
O
MES Gen 1 and Gen @ Control Panel wiring
Yes, that is what I meant in my post - shorting the +5V and heat wires with the resistor and using the Auber. The question is though: how to make absolutely sure that the red and the blue are the wires that need to be jumped? I guess I need some crash course on how to figure that out with a...- OPri
- Post #10
- Forum: Electric Smokers
-
O
MES Gen 1 and Gen @ Control Panel wiring
Thank you, tallbm, so much for your reply and instructions! I was thinking about making something like this with the Inkbird: https://www.smokingmeatforums.com/threads/mes-pid-controller-no-drilling-of-rivets-no-high-voltage-wiring-required.237746/ I'm going to try and see if I can confidently...- OPri
- Post #5
- Forum: Electric Smokers
-
O
MES Gen 1 and Gen @ Control Panel wiring
I'm a not so proud owner of two MES 30 - one is the older Gen2 and the other one is a newer Gen1. The Gen2 had served me faithfully for 6+ years until the control panel got moisture in it. It still works but throws fits once in a while (quits in the middle of the process, etc). The newer Gen1 I...- OPri
- Thread
- Replies: 10
- Forum: Electric Smokers
SmokingMeatForums.com is reader supported and as an Amazon Associate, we may earn commissions from qualifying purchases.
SmokingMeatForums.com is a community of barbecue and outdoor cooking enthusiasts dedicated to smoking meat.
© 2004-2026 SmokingMeatForums.com
