Toggle sidebar

Recent content by HannibalFP

  • Some of the links on this forum allow SMF, at no cost to you, to earn a small commission when you click through and make a purchase. Let me know if you have any questions about this.
  1. H

    reverse flow calculation

    ok, so far so good, my final dimension will be 56 long x 30 wide x 40 tall FB is 30 long x 27 wide x 30 tall (insulated) cooking chamber is 67200 square inch FB/CC opening =268.8 = 27"x10" FB inlet = 67.2 divided in 80% and 20% =54 and=13.5 ESV=1478 plus 30%=1921.92 Exhaust calculation 7.2 X...
  2. H

    reverse flow calculation

    ok thank you very much, I will install, the grease retainer on the baffle plate. I thought that a 4 inch space between the food rack and the baffle plate is enought. What do you recommand?
  3. H

    reverse flow calculation

    I know how to use the the calculator but I dont understand how to manage the volume below the baffle plate. the space below the baffle plate is like a chimney who conduct the smoke and the heat to the opposite of the smoker and then is felivered inside the cooking chamber and the food rack. the...
  4. H

    reverse flow calculation

    hello daveomak I have been using this link. What I am trying to say is the following following this calculator for the reverse flow and taking some measurement I obtain this area for the fb/cc chamber 216 square inch, so the opening will be 27x8=216 so my baffle plate will be 8 inch high from...
  5. H

    reverse flow calculation

    hello everyone, First of all I would like to apologize for my bad english. I am planning the build of a reverse flow smoker that I could use for a whole pig. I have a question about cooking chamber volume/ baffle plate(volume) When I use the calculator they ask to use the volume of the cooking...
  6. H

    hello from Panama

    right now I am in the drawning phase. I have to make some change because i decided to go with an insulated firebox.
  7. H

    hello from Panama

    Hi jcam yes at the begining I was planning something easier, but I need something much bigger.
  8. H

    hello from Panama

    Thank you very much guys. I have been looking around about the build but I think that I will have to make one myself
  9. H

    hello from Panama

    Hello, My name is Julien Costa, I live in panama, I work in sportfishing industry and I allways be interested in smoking and cook in general I have been using very rudimentary smoker made from scrap and without many knowledge. the result was very promising, and now after reading this forum for...
See more
Top Bottom
Back
Clicky