-
Some of the links on this forum allow SMF, at no cost to you, to earn a small commission when you click through and make a purchase. Let me know if you have any questions about this.
Recent content by goalieguy29
-
G
masterbuilt 560
Got three switches from Amazon, replaced the grill lid switch...and It WORKED! THANKS so much for your help, still no response from MB... My best! Matty- goalieguy29
- Post #13
- Forum: Roll Call
-
G
masterbuilt 560
You were RIGHT, the pin was bent/never noticed it. Tried to bend out but pin still "sticky" and then pin came out completely. (This grill was pretty beat and bent from shipping...) Still stuck at 500. Will try to get a replacement or worst case hard wire it..THANKS!- goalieguy29
- Post #11
- Forum: Roll Call
-
G
masterbuilt 560
In Peterborough, 1/2 hour from Keene. Everyone loves this 560 to sear at 700....the grill lid limit switch is definitely *bent/broken.- goalieguy29
- Post #10
- Forum: Roll Call
-
G
masterbuilt 560
Thanks! Then hopper door and the cleanout door are firmly shut, grill hood shit well, all else working good. (No help from masterbuilt yet. )any other thoughts?- goalieguy29
- Post #4
- Forum: Roll Call
-
G
masterbuilt 560
Hi All! New guy from NH here. Have a brand new Masterbuilt 560 that I just finished initial burn. All seems to be working great, fan etc, burn went well, but temp will not go above 500 degrees. Regulates there, even though temp on controller set to 700...any ideas?- goalieguy29
- Thread
- Replies: 12
- Forum: Roll Call
SmokingMeatForums.com is reader supported and as an Amazon Associate, we may earn commissions from qualifying purchases.
SmokingMeatForums.com is a community of barbecue and outdoor cooking enthusiasts dedicated to smoking meat.
© 2004-2026 SmokingMeatForums.com
