Recent content by Bobnrtp

Your model is the last one listed so it may work. I have the same model that you have and it looks like a different board. I had this same problem with mine a few weeks ago and like you didn't want to spend the $$. I did break down and got the Aubor PID. So glad I did. I set the temperature at...

Bourbon 1792, Scotch Glenfidich 12

Auber has the WSD-1200H PID on sale until July 7th for $147.00. Not available on Amazon but I found it on there WEB site.

Tallbm, Thank you so much for the detailed expiration . The link to the MES rewire was also very helpful. Looks like something I can do easy enough. I have already removed the circuit board cover. So after they rewire the MES is plugged into the PID controller and the PID controller has its own...

Sorry for the confusion My controller was the original MES controller. The other one was from a different MES.

I pulled the cover off the control board and it looks like new. No hot spots or bulging components.

Yes that was one of the first things I tried. Thanks for the suggestion,

Just tried again with 2 Taylor and a TermoPro remote thermometers/ All three were close 1 or 2 degrees from each other. The MES control panel read about 11 degrees cooler. Again the Red LED light went off at 200 as I had it set, but temps went up to 300 and kept climbing. So I shut it down.

It stayed over temp

I have an older MES model 20070910 I can set the temp to 200 and start heating. When it gets to 200 the Red LED turns off, but it continues to heat going up maybe 40 more degrees. I put my controller on another smoker and it works fine. Used the other controller on my smoker and it still...