Recent content by Bigern26

  • Some of the links on this forum allow SMF, at no cost to you, to earn a small commission when you click through and make a purchase. Let me know if you have any questions about this.
  1. B

    Turning a Pellet Grill into a cabinet smoker

    Can you elaborate as to why? Would it be because of making it larger? I know by changing my p setting on the grill I can smoke at 150 no problem. I have made hundreds of pounds of venison bacon, summer sausage, and sticks on the grill over the years.
  2. B

    Turning a Pellet Grill into a cabinet smoker

    Thinking I might try building a cabinet smoker out of my pellet grill. I recently upgraded our pellet grill and have a Pit Boss 820D just sitting around. My thought is to cut the grill all the way around horizontally then weld up a 3/4" square tube frame to go on top of it and skin both sides...
  3. B

    Building a Propane Smoker

    Less than $100 for that large of a smoker? Please tell me the secrets. How would I make the smoke? Here is a build I did a few years ago that was a flop. Could not get the smoker hot or to stay hot. Smoke was terrible from the smoke generators. I scrapped this build. This is why I want to go...
  4. B

    Building a Propane Smoker

    I just picked up a really heavy steel cabinet that is 6' high x 4' wide x 2' deep. My build would basically be for smoking venison bacon, snack sticks, and summer sausage. Occasionally maybe some regular bacon, other sausages, and pork butts. My though was to cut the shelves out and build...
  5. B

    Holy Smokes - Commercial Heater Build

    Testing smoker. Plus side I didn’t get electrocuted or burn up anything. Lol It takes longer than expected to ramp up. From 76 to 170 it took about twenty minutes to half hour. I will time it for sure once I get the real wiring done and get it set in place in the car port. Got the 2 smoke...
  6. B

    Holy Smokes - Commercial Heater Build

    Control box mounted, element installed, top cover reattached, now to cover wires, install smoke generators, run wiring to final location and do a few finishing touches before test firing
  7. B

    Pid wiring question

    Would this be ok on the block? Hot going in with jumper going to next spot. Other side will go to SSR and and other side of jumper will go to 110 outlets. Then on the SSR the out contains wire for element and indicator light. Would that work? PID and lights are both going to be wired 110
  8. B

    Holy Smokes - Commercial Heater Build

    Would this be ok on the block? Hot going in with jumper going to next spot. Other side will go to SSR and and other side of jumper will go to 110 outlets. Then on the SSR the out contains wire for element and indicator light. Would that work? PID and lights are both going to be wired 110
  9. B

    Holy Smokes - Commercial Heater Build

    I am hoping to get up to at least 250 to 300. i want to use it for everything from cold smoke to cook. Insulation is heat resistant fiberglass.
  10. B

    Holy Smokes - Commercial Heater Build

    Here I will be showing my build. After lots of help from dward51 in another thread with wiring (thanks again) and Auber Instruments, I am ready to start a build thread. Starting with a Commercial heating cabinet. Double doors on each side and already had a smoke daddy generator from previous...
  11. B

    Pid wiring question

    I see that now, Thats not how it will be, both hots will go through the breaker and then split off.
  12. B

    Pid wiring question

    TC will be going through a grommet that I already have the box drilled for. 110v outlets are only there for air pump on generators. If cold smoking I will just plug them into to the regular outlet in the car port. Indicators are just lights not switches. Only switch now is a 2 pole 25a breaker.
  13. B

    Pid wiring question

    OK, Indicators I have are 220v only. How does this look?
  14. B

    Pid wiring question

    Will do, thanks
  15. B

    Pid wiring question

    Is there a difference running the PID 110v vs 220v?
See more
Top Bottom
Back
Clicky