Toggle sidebar

Recent content by alaskanyoung

  • Some of the links on this forum allow SMF, at no cost to you, to earn a small commission when you click through and make a purchase. Let me know if you have any questions about this.
  1. alaskanyoung

    Spray in foam

    Has anybody used this to remove foam? https://tedgar.net/index.php/en/
  2. alaskanyoung

    Black Bear Jerky with Pics

    Black bear jerky. Interesting! Hope it was good.
  3. alaskanyoung

    Spray in foam

    I sincerely hope the hard part is over
  4. alaskanyoung

    Spray in foam

    Im curious how to put it back together. There will be nothing to bolt to because the insulation is gone and youve created a gap using a crowbar and hammer down the seem.
  5. alaskanyoung

    Traulsen Commercial Refrigerator build

    Two hrs later ive almost got one wall off. Metal tears really easy. Trying to be gentle. This is an absolute NIGHTMARE.
  6. alaskanyoung

    Spray in foam

    Its taken me almost two hrs to get one wall off. Not sure if im doing it right or not. Trying not to bend and rip the thin metal
  7. alaskanyoung

    Spray in foam

    I think im going to chalk this project up as a loss. The cabinet was $100. The hoppers were $900~ and about $50 in misc expense. I dont think i want to get too far into removing this foam. It is an absolute nightmare to deal with.
  8. alaskanyoung

    Spray in foam

    What is the easiest way to remove spray in foam from a traulsen? What tools have you used?
  9. alaskanyoung

    New Stainless Fridge Build - looking for advice

    I just about completed my build tonight and am just now hearing about tearing out the spray foam. Should have reaearched before i got after it.
  10. alaskanyoung

    Traulsen Commercial Refrigerator build

    Did you re insulate? How did you take it apart? Im about to run into the same problem i think. Pretty upset about it.
  11. alaskanyoung

    Aluminum angle

    Does anybody have thoughts about using aluminum angle iron instead of steel angle for buildings the siding/slots that will hold racks in place? Ive heard some complaints about aluminum releasing harmful vapor.
See more
Top Bottom
Back
Clicky