Two issues I have run into both regarding temperature.
The first one is probably the largest issue. The butt is stuck at ~185. I thought this was too high for a stall, so I wanted to check it out. The reading on my MES is 230, the reading on my Macverick is 228, and the temp on the meat probe inside is 191. I tested the Maverick last night in some boiling water and it read fairly close so I figure 2/3 takes it. Is this too high for a stall and require a trip to the oven while I figure out what is going on or do I just need to sit down and find something to do other than staring at this thermo?
While smoking a butt last night I ran into a problem with my new MES40. While it was heating up and I was trying to sort out the AMNPS I noticed the temp had switched to 275. I figured I set it up wrong(wouldn't be the first time) so lowered it and really didn't think anything more of it. But later when I glanced at my thermo I noticed the temperature was going up to 250+. When I went outside to make sure everything was ok I found that the control had reset the temperature to 275 again and it was trying to climb to that.
Has anyone else had this issue?
Daniel
The first one is probably the largest issue. The butt is stuck at ~185. I thought this was too high for a stall, so I wanted to check it out. The reading on my MES is 230, the reading on my Macverick is 228, and the temp on the meat probe inside is 191. I tested the Maverick last night in some boiling water and it read fairly close so I figure 2/3 takes it. Is this too high for a stall and require a trip to the oven while I figure out what is going on or do I just need to sit down and find something to do other than staring at this thermo?
While smoking a butt last night I ran into a problem with my new MES40. While it was heating up and I was trying to sort out the AMNPS I noticed the temp had switched to 275. I figured I set it up wrong(wouldn't be the first time) so lowered it and really didn't think anything more of it. But later when I glanced at my thermo I noticed the temperature was going up to 250+. When I went outside to make sure everything was ok I found that the control had reset the temperature to 275 again and it was trying to climb to that.
Has anyone else had this issue?
Daniel