I wanted a better place to do cold smoking other than my Brinkmann Offset, so after reading several threads and getting ideas from other people, I came up my own. The interior dimensions are 2' x 4' to mach the aluminum sheet I had.
It's 3/4 plywood lined with aluminum sheet. While it will be just for cold smoking, I thought the aluminum will be easier to clean. I will need to come up with an electric heat source for the winter months, but for now I will use the Smoke Daddy or the A-Maze-N-Smoker.
It will all be insulated and when done, covered with vertical cedar siding...I have some left over from my house.
Heres where I got today:
Gluing the aluminum sheet onto the plywood:
Pieces all cut:
Aluminum Sheet:
Sideways view of gluing down the bottom which I forgot to do before:
Not sure how to rotate...sorry! Interior lined:
Enough for today:
It's 3/4 plywood lined with aluminum sheet. While it will be just for cold smoking, I thought the aluminum will be easier to clean. I will need to come up with an electric heat source for the winter months, but for now I will use the Smoke Daddy or the A-Maze-N-Smoker.
It will all be insulated and when done, covered with vertical cedar siding...I have some left over from my house.
Heres where I got today:
Gluing the aluminum sheet onto the plywood:
Pieces all cut:
Aluminum Sheet:
Sideways view of gluing down the bottom which I forgot to do before:
Not sure how to rotate...sorry! Interior lined:
Enough for today: