or Connect
New Posts  All Forums:Forum Nav:

strip heater question

post #1 of 3
Thread Starter 
I've read about finned strip heaters needing a fan or something that creates a draft around it so they don't burn up. If this is true, could I drill a 2" intake behind it with a ball valve to help with that or would it be too close or the heat causing the ball valve to stop functioning properly. (Teflon gasket). Also have a smoke daddy. Thanks for the input.

post #2 of 3
Using a fun Ed stop. Heater in my current build. Will upload a pic of the set up so far. It's going to work awesome. For air flow and a clean out in the bottom. Under the heater.
post #3 of 3
Thread Starter 
Cut the hole already. However I do still have the cut outs. Sounds like a good multifunctional idea. Might have to see if I can do something like that on my fridge. Its a lot like smokednarwhals fridge. Appreciate the feedback Mr. Mike.
Edited by Pithand - 3/12/15 at 6:02am
New Posts  All Forums:Forum Nav:
  Return Home
  Back to Forum: Fridge/Freezer Builds