Toggle sidebar

Featured Dynoglo propane question.

  • Some of the links on this forum allow SMF, at no cost to you, to earn a small commission when you click through and make a purchase. Let me know if you have any questions about this.
Remove the Ads for LIFE - 50% Off!
SMF is reader-supported. When you buy through links on our site, we may earn an affiliate commission.
J

Jwgforce

Newbie
Original poster
Apr 9, 2020
1
0
Smoker runs at 300 with both burners on low. Need to cook with both on or food doesn't cook right. Thinking of drill 2 4inch holes onto and installing a needle valve. Any thoughts
 
You must log in or register to reply here.
SmokingMeatForums.com is reader supported and as an Amazon Associate, we may earn commissions from qualifying purchases.

Similar threads

cashnow
Howdy from Louisville
Replies
9
Views
1K
Roll Call
mneeley490
mneeley490
C
Attn: Char-grille XD Grand Champ drivers..I gots questions!
Replies
13
Views
2K
Wood Smokers
DonP
DonP
G
MES with Cold Smoker Attachment -- Am I doing it wrong? Ways to not smell like smoke?
Replies
27
Views
1K
Electric Smokers
tpc74
tpc74
G
Computing water activity without having to spend $500
Replies
18
Views
598
Food Safety
geostriata
G
titus0327
SV brisket points/flats separately & translating previous corned beef points success
Replies
1
Views
279
Sous Vide Cooking
JIMSMOKES
JIMSMOKES
J
Whole hog..broken down?
Replies
0
Views
932
Pork
Jokerswild!
J
Cotosoti
Are These PID Settings Reasonable (after Auto Tune) 2nd Gen MES 40"
Replies
14
Views
1K
Electric Smokers
dsk
D
Culinary Otter
Attempting First Cold Smoke
Replies
14
Views
2K
Info and Practices
Culinary Otter
Culinary Otter

Latest posts

Hot Threads

Top Bottom
Back
Clicky