Search results

  • Some of the links on this forum allow SMF, at no cost to you, to earn a small commission when you click through and make a purchase. Let me know if you have any questions about this.
  1. mazakbill

    MES 30 element voltage issues

    Thanks a bunch DaveOmak I'll get one ordered ,I figured someone has replaced theses with aftermarket ones on this forum and would lead me in the right direction .  
  2. mazakbill

    MES 30 element voltage issues

    Well after more checking and double checking it turns out it was the overtemp button switch that DaveOmak was talking about ,when I checked it the first time and had all the wires hooked up on the control board  I seem to remember getting voltage on both sides of the overtemp switch but when I...
  3. mazakbill

    MES 30 element voltage issues

    O.K I will do that tonight and see what it is Thanks that should tell me if that is bad even though its a brand new element from masterbuilt I am also going to hook up a wire on the output side of the element and run it to the common side of the power cord to see if the element get hot ,then...
  4. mazakbill

    MES 30 element voltage issues

    Checked over temp and i have voltage going thru , when power is on and all other functions work like setting temp ,time probe temp light inside smoker , what pizzles me is I have the 110 voltage going to one side on element and it comes out the other side but I'm guessing I'm missing circuit.I...
  5. mazakbill

    MES 30 element voltage issues

    @ Daveomak I'd like to stay with MES if I can ,I like the remote monitoring for it with temperature and probe....  @ daricksta   I will be calling again to discuss my options on this that's for sure ....
  6. mazakbill

    Gasket

    This shows the gasket around the edges, the door needed to be reattached because of rust and had a 3/4 gap and was twisted .with this sometimes I have to pry it open with a screw drive it seals so good.
  7. Gasket

    Gasket

  8. image.jpg

    image.jpg

    • mazakbill
    • Media item
    • Comments: 0
    • Album: Gasket
  9. mazakbill

    Gasket

    On my frig smoker door gasket I just used the 1 inch foam door seals from home depot that has the ons side that has the sticky tape that you pull off ,it worked great and compresses for a great door seal .
  10. mazakbill

    MES 30 element voltage issues

    Hi all Just replaced my 800 watt element with a new one from Masterbuilt no problem there but now I have 110 volts on the element  but it doesn't get hot .checked all wires and connections continuity on element is good my ? is could the control board on the bottom be bad ? all the wires are...
Top Bottom
Back
Clicky