-
Some of the links on this forum allow SMF, at no cost to you, to earn a small commission when you click through and make a purchase. Let me know if you have any questions about this.
-
M
Well, after all of these years, I finally did it.
Looks nice. I'm not too sure about the recalls and the Duramax/Allison combo. I just sold my diesel and miss it. 215k miles, 50mpg.- Mudpie
- Post #54
- Forum: General Discussion
-
M
Inkbird 106 Controller Issue
I need help. I have been using a Inkbird 106 controller for some time for smoking. I leave it set at 230F. Its 20F outside plus the wind chill. Today, my controller wont go past 160F +/-. I double checked all my settings. The Output light is steady. Any ideas?- Mudpie
- Thread
- Replies: 1
- Forum: General Discussion
-
M
PID Troubles
Update. I reset the PID to P=1 I=0 D=0 and it will hit my target temp and hold it.- Mudpie
- Post #4
- Forum: Electric Smokers
-
M
PID Troubles
I have a Backwoods Smoker G2 in which I recently built a PID controller common on other forums connected to a 1800 watt smoker heating element. I can never get it to reach the higher temps (260-275F) without crashing back into the low 200s. Ive tried AutoTune but it take hours to get over 240...- Mudpie
- Thread
- Replies: 7
- Forum: Electric Smokers
SmokingMeatForums.com is reader supported and as an Amazon Associate, we may earn commissions from qualifying purchases.
SmokingMeatForums.com is a community of barbecue and outdoor cooking enthusiasts dedicated to smoking meat.
© 2004-2026 SmokingMeatForums.com
