Some of the links on this forum allow SMF, at no cost to you, to earn a small commission when you click through and make a purchase. Let me know if you have any questions about this.
Had a chance to check the iGrill in a pot of water last night. And check against my Maverick in the same pot. All registered withing 1 degreebof each other as I raised temperature from 65 to boiling. Did this over about an hour to stabilize the readings. So wxt, I suppose I need to put the...
Needle valve installed or back the burners in between high and off. A lot of folks will use that position temporarily to see if they want a needle valve.
Just looked at this one in Sam's Club and compared it to my current Smoke Hollow. They changed the bottom area dramatically. The slide out chip trays are nice, but way too shallow to use for chunks. The big chromed knobs are nice. Inside the burners are the same as the previous models. I can see...
Igrill2 was not accurate over Christmas!! I set up 4 probes in a boneless prime rib. The meat was very uniform in mass. The probes had a 20 degree tempurature spread. I traded connections and positions in the meat and on the base unit. For reference I used my old Maverick 732 and a Thermapen...
Go get it Rippper. It will not dissapoint. I used it on the trimmings last night. Seared in cubes in cast iron pan. Then put the L and P on it. Covered and into oven to slow cook. Made a gravy from the juices and we had that over egg noodles for late supper.
I intend to try it as my base on...
Just so y'all know, the favorite prime rib coating for a few of us has changed. It used to be the Lea and Perrins Thick Classic Worcestershire Sauce. Well. that is gone and has been replace by the Lea and Perrins Bold Steak Sauce. It has the thick consistency and the flavor seems to be that of...
I am going to be doing the same thing. I have about 13-14 people coming over for Christmas dinner. So I picked up the entire standing rib roast to cook. Now, I am looking at a 23lb chunk of cow that cost me about $170.00. I will be going low and slow. And I agree that since it is uniform in...
Did a smoke with the new iGrill system. I enjoyed the ability to have it on my phone or tablet. It did
seem to go to "sleep" or disconnect a couple times. It was sitting on the coffee table and registering
just fine, the 5 minutes later it was disconnected. Not sure if it is and Android thing...
Got a pair of thw igrill2 systems from Amazon. Each unit $65.00. Downloaded the Android application to phone and tablet. Both work well. And I was able to monitor both units from within the app. Took a couple times to get it dialled im
Ok, got the two igrill2 units. Both are working well. I can get about 100 feet and 2 walls maximum. But, for bluetooth that is just fine. So I have 2 yellow and 2 red probes
I hate spending $7.00 to $10.00 for that little "A" clip for the probe. And sometimes it does not fit where you want it. I like the tea-light container trick.
Bet I can make a bunch of silver dollar size discs. And I like the idea of one on top of grate and one below. Hang the probe vertical...
I will also say the 732 is an excellent unit. My smoker can be about 200 feet from the receiver at times. There are 2 walls between. It will continue to
work well. I put the smoker under my carport area of the garage. Then go to bed and put the receiver on the nightstand. I am sure the 733 is...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.