Toggle sidebar

Search results

  • Some of the links on this forum allow SMF, at no cost to you, to earn a small commission when you click through and make a purchase. Let me know if you have any questions about this.
  1. dockman

    What is a good price? Used MES 40"

    I think if you can pick it up for $150 that would be a good deal!
  2. dockman

    How much charcoal?

    Depends on smoker but I think 30 lbs would be enough?
  3. dockman

    Internal tem,, help?

    If meat in juicy, tender, and pulls easy why go higher IT?
  4. dockman

    Hello from MO

    Welcome to the forum
  5. dockman

    First smoke on Oklahoma Joe (The new one)

    Oh yea them look tasty
  6. dockman

    Do Reverse Flow Smokers Need Drains?

    They come in handy when rinsing out!
  7. dockman

    First Baby Back Ribs

    They look good!
  8. dockman

    First Baby Back Ribs

    Well which ones were better?
  9. dockman

    model ET 732 redi check

    Spray bleach works good
  10. dockman

    pork shoulder questions

    I cut it off and also inject with Creole butter and apple juice (50/50 mix) the night before. I was watching Pit masters the other day all 3 contestants left the thick skin on.
  11. dockman

    Oklahoma Joe Longhorn size questions

    I have some 3/16" and some 1/4"
  12. dockman

    Oklahoma Joe Longhorn size questions

    May plates are 26" over from CC then a 2-1/2" gap to last plate which is 4" wide! My plates are 17" long.
  13. dockman

    Oklahoma Joe Longhorn size questions

    I also decreased the size of my FB to CC opening and changed exhaust to be all the same size as the pipe welded in the CC. I do feel the inlet is to small so I run it with door open until temp comes up then shut door and adjust accordingly. I did trim inlet opening so it would be as big as it can be
  14. dockman

    Oklahoma Joe Longhorn size questions

    My OKJLH takes a long time to warm up but once there it holds 225-250 easily. My tuning plates are gapless from FB to a little over half way across CC then have another plate with small gap and my pit temps hold less then 5 degrees difference from side to side. I tried putting small gaps all...
  15. dockman

    OK Joe Mod question

    The plate with an angle next to fire box is welded in. I bolted it first but then figured since I have a welder just as well weld up the gaps. The other plates just lay in place.
  16. dockman

    OK Joe Mod question

    Here is my plate!
  17. dockman

    Help!!!! I mod my old SNP to RF and can't get the TEMP UP

    Is there a chance you simply are not using enough charcoal? My Oklahoma Joe will not get good heat unless I load it up with a good amount of charcoal.
  18. dockman

    OK Joe Mod question

    I built my own out of 1/4" plate. No holes in mine and with a few tuning plates it works prefectly.
  19. dockman

    HELP! 1st shoulder in smoker, think something's wrong

    That is a fast cook. 8 lb would take me 7-8 hours at 225-250 and then an hour rest!
  20. dockman

    What am I doing wrong?

    If all grey in chimney the coals on bottom are pretty much done by the time you dump. I fill my FB basket with 10-12 lbs then fill chimney. Lite chimney let it burn for 15 minutes or so then dump.
Top Bottom
Back
Clicky