Some of the links on this forum allow SMF, at no cost to you, to earn a small commission when you click through and make a purchase. Let me know if you have any questions about this.
You are using an out of date browser. It may not display this or other websites correctly. You should upgrade or use an alternative browser.
...me dial in my MES 40. I smoke a lot of summer sausage and snack sticks and the temp swings in the MES were killing me. I finally bought an Auber PID and I’m working on rewiring the MES to bypass the controller. I was using @tallbm guide and our wire configurations are a bit different. Can...
Wiring help needed for newer MES 40. I have 4 wires total coming out of where the power cord is. Besides the white and black power wires, the other 2 are red and blue. Which wires should I connect to use my PID. Any help would be appreciated.
Let us know how it works out. I would like to give my opinion of PID controllers for smoking. I have used my analog Smoke-it #2 since 2013, smoke most everything at 225' dial setting. It cycles on and off like a kitchen oven bakes a cake. If a brisket can be smoked at 225, 250. 275, or even...
...and pinch the corners which I do to the larger one to make it 12.5"×17" which is also deeper. I never needed water for temp stability with the PID controller or for smoke adhesion so I don't use water. Just evaporating meat juices from the pan. This pic is the Mes 30 with a Dollar Tree cake...
...and made their own. I build such things for a living, so that might happen. Maybe an Arduino and a K type thermocouple and then use a separate PID controller which is what they did (the PID controller part). I have several sitting around, but It's not really a fun project to me. If I do...
...reaching max temp. for quite some time. I think it's time for some upgrades. I've been looking at a Savannah Stoker controller, but I read it works more like an oven and won't produce as much smoke. So I'm not sure a PID controller is what I want! Any other suggestions are greatly appreciated.
I'll also say that I did have some initial issues with the Auber PID settings, but the Auber customer service folks took care of me and got me dialed in.
So I smoked a batch of summer sausage today and noticed my Inkbird PID temp display going crazy. Say my temp was set at 150°. When it got close to target temp, it would quickly start jumping from 149 to 155 to 147 to 150 and so forth. Would do that for about 5 seconds then quit and settle on a...
Did you actually verify your PID pit temps with a digital thermometer? PID controller may need some calibrating, it may have been running hotter than anticipated.
They look good though, I would put a few of them away.😋
...well... For both the SSR connections and the heat element connections... You won't need them on the low voltage +/- signal wires coming from the PID to the SSR ( I am assuming that is how the Inkbird works as that's the way the Auberns is. Let me know if it's different)...
Are you running...
Anybody ever rewired a newer masterbuilt smoker to run an auber pid. I have a two black wires, a red, and a white. Trying to figure out what wires need to be wired together for the auber to take over.
Thanks