Recent content by zsmeats

So last night I was working on getting the RF plate tacked in I don't wanna weld till I get some opinions This is at the FB/CC opening the tape is held against the bot of the RF plate is this to high/low? Same here tape is held against the bottom of the RF plate This is the RF plate CC...

So the RF plate is supposed to be mounted at the same height of the top of the CC opening correct?

I worked a few hours sat and a little bit Sunday and here's where' I'm at got the firebox built, CC doors welded straightened and lower rack built (no pic yet) I want to put a pipe for a RF plate drain on either the FB end or at the RF opening was wondering which way of tipping the RF plate...

Well the cook chamber itself is only 1/8" thick so that will probly rot out before the fire box

Well here's what I've gotten done so far I got the FB/CC opening cut and doors cut out and mounted I'm getting ready to build my firebox but have a couple more questions is 3/16" mild steel to thin for a firebox and what a good thickness for the RF plate

Well after tossing ideas around for a week I've decided to stand it up because I do want to trailer mount it

I bought this a week ago and I plan to make it into a reverse flow and leaving it flat as shown in the picture the dimensions are 43 3/4" wide 26 3/4" tall and 60" long. I having a little trouble locating the RF plate I got the square inches figured out but don't know how far off the bottom it...