Toggle sidebar

Recent content by tandito

  • Some of the links on this forum allow SMF, at no cost to you, to earn a small commission when you click through and make a purchase. Let me know if you have any questions about this.
  1. tandito

    Smoker build

    Thanks! Interesting idea, That's seems very reasonable to do. I have try to do some research on these types of smokers and haven't run into much info on them.
  2. tandito

    Smoker build

    these openings are about10"wide with a peak gap of 1.5"= roughly 30in^2 on either side. i deffinitly had my concerns with this and wouldve liked to get more area coming up the sides it also stops a few inches below the top of door
  3. tandito

    Smoker build

    that is [rectangular tubing at 2.5''*8"=an area of 20in^2] with a [4'' exhaust attached=an area of12.5in^2] I hope i understand you, and i dont know what the rough dimensions should be for this but the exhaust plenum is bigger than the exhaust its self so i thought that would be sufficient?
  4. tandito

    Smoker build

    Correct, that was the goal. I didn't know if it was possible and did zero research on if a vertical offset smoker Is possible😂
  5. tandito

    Smoker build

    *hope this diagram helps some i can try taking more pics this weekend in the light of day. *In theory the outlets are bigger than the inlet, but i think i need to increase the flow down low up the sides drastically *the reason for the fire pot beeing off center and having an angles plenum is...
  6. tandito

    Smoker build

    Hey y'all, new to the forum👋 and just hoping to get some insight on If I have waisted my time on this build or might be able to salvage it. Tried to build a vertical offset smoker, pellet box comes in the bottom hits a baffle plate and essentially goes up channels on the sides. Under baffle...
See more
Top Bottom
Back
Clicky