Recent content by Rumblefishstix
-
Some of the links on this forum allow SMF, at no cost to you, to earn a small commission when you click through and make a purchase. Let me know if you have any questions about this.
-
R
New to the site and first build
Well a potential covid case at work has cut down on production. Next week however we should be good to go and hopefully over the long weekend, I can get some of the knick knack stuff done, like the chimney and log rack and grates.- Rumblefishstix
- Post #10
- Forum: Reverse Flow
-
R
New to the site and first build
Well progress is being made. Question what’s a good rule of thumb for fire grate level in the firebox?- Rumblefishstix
- Post #7
- Forum: Reverse Flow
-
R
New to the site and first build
Question for everyone any advice on the door straps tweaking the door and how to get the curve back in the door? Right now my thought is heat and possibly lots of it. It seems like it’s just the 4 corners.- Rumblefishstix
- Post #6
- Forum: Reverse Flow
-
R
New to the site and first build
Advice for the next build. Send the tank to get media blasted prior to cutting on it..........- Rumblefishstix
- Post #5
- Forum: Reverse Flow
-
R
New to the site and first build
Well this was today’s work. I ordered the 1/4 plate for the firebox, should be here Monday and I’ll have my guys run it through the plasma table so it’s ready for construction. This weekend’s tasks are to clean the cuts up since the plasma cuts weren’t super smooth, then clean the outside of the...- Rumblefishstix
- Post #4
- Forum: Reverse Flow
-
R
New to the site and first build
So tonight was rather uneventful and a few set backs. Fought the plasma gun for a few hours after work, but did manage to get both legs cut. Tomorrow the shop is gonna cut my hinges, so we'll cut the door. Decided for ease of installation to go with a 36"x24"x24" firebox. The round pipe I...- Rumblefishstix
- Post #3
- Forum: Reverse Flow
-
R
New to the site and first build
Gents and ladies, I've been lurking for a while during a search for some free materials to build a RF smoker. I finally found an old tank off a job we are doing and decided I'd take the plunge. I've attached several pictures. I have a question on whether or not to utilize a 24" round pipe for...- Rumblefishstix
- Thread
- Replies: 9
- Forum: Reverse Flow
