Recent content by Michael Hornbeck

Thanks for the reply. I just cut one end off the 250 Gallon propane tank with a plasma cutter after breaking three cutting disks, at least now I have a fire pit! It was my first time with a plasma and I learned a lot just on that portion. I have the tank situated on the trailer and am about to...

I used the build calculations link from SMF posted in many threads on this forum because I read where it included a tweak to other calcs specifically for reverse flow. My plan was to make the FB cut first then the doors, for two reasons. 1.) The warping that can occur on the doors when...

I have calculated actual volume to be 283 gallons. Now I am assuming my CC half moon cut is made when the diameter of the lower chamber is 26.791 inches and is 8.25 inches from the bottom. Are these correct assumptions? Thanks in advance for any help!

CALCULATIONS by Michael Hornbeck posted Feb 16, 2018 at 12:06 AMCircle Calc by Michael Hornbeck posted Feb 16, 2018 at 12:02 AMI have begun preparation on a 250 gallon propane tank to turn it into a great smoker for large cooks like the wedding I was asked to provide brisket and pulled pork for...