-
Some of the links on this forum allow SMF, at no cost to you, to earn a small commission when you click through and make a purchase. Let me know if you have any questions about this.
Recent content by joecaboose
-
Masterbuilt 20051311 modifications
I had no problem holding a consistant 200 for hours. Before the modifications, I was lucky to keep it at 260. I have not tried (yet) any temps lower. Will post results when i do. Joe- joecaboose
- Post #3
- Forum: Propane Smokers
-
40 inch masterbuilt elite gas smoker. Can't get temp below 275 degrees
Couldn't get mine to stay under 250.....here's my fix: Closed off 1/2 jet openings with #6 brass screws Installed LP needle valve Reduced lower vent opening Added Green Egg door insulation Added casters WHAT A DIFFERENCE.....!- joecaboose
- Post #5
- Forum: Propane Smokers
-
Masterbuilt 20051311 modifications
My issues: Difficult to move, leaking doors, impossible to maintain consistant heat under 250 degrees, suseptible to drafts Modifications: Added casters Sealed doors using Green Egg insulation Installed LP needle valve, closed off 1/2 burner jets (#6 brass screws) Reduced the lower vent...- joecaboose
- Thread
- Replies: 5
- Forum: Propane Smokers
SmokingMeatForums.com is reader supported and as an Amazon Associate, we may earn commissions from qualifying purchases.
SmokingMeatForums.com is a community of barbecue and outdoor cooking enthusiasts dedicated to smoking meat.
© 2004-2026 SmokingMeatForums.com
