Recent content by JayMc
-
Some of the links on this forum allow SMF, at no cost to you, to earn a small commission when you click through and make a purchase. Let me know if you have any questions about this.
-
J
FB / CC opening question
Hello all. I know this question gets thrown about way too often, but I've got a twist that I haven't seen answered previously. Given said FB with a 4.688" depth of cut to the CC, and a 2" relief cut on the top, the opening (on the diag) is larger than the vertical cut. (5.029" vs 4.688") My...- JayMc
- Thread
- Replies: 0
- Forum: Reverse Flow
-
J
Greetings from the sandy wastelands!
Doug, Keith, Jack - Thank you for the warm welcome. Keith - SE Georgia, like near Columbus? Spent several uncomfortable months there training in the 80's! Jack - Thank you for the link. I am very versed with that thread. It has been a wealth of knowledge! Jay -
J
Greetings from the sandy wastelands!
Greetings! Been a lurker here for a while, but felt the need to join the community. Lots of great experience and good information being tossed around here. I come from a Fabrication point of view, but in the last few years, I've moved to design work. Where I'm currently situated, welding...
