Recent content by hog hunter

Well back to square one

So any thoughts on if in waisting my time continuing on with this tank

That's what I was thinking but on tape it's 1/16 the inside is pretty rusty

So slow progress and now big disappointment just getting around to cutting my FB/cc opening and got a look at how thick cc is and it's only .03 thick is this worth my time to continue or should I find a new cc

Ok thanks will look into another way for hinges

So thinking door hinges so any reason this wouldn't work? Have pivot point about top of magnet.

No turning back now

Ok thanks guys it's only 3/16 thick and firebox is oversized not sure off hand by how much

Firebox question. My tank I'm using for firebox isn't as thick as I would like but going with it so if I need to I'm going to insulate it, but going to try it first. If I do insulate it do I need to reconfigure the size of the box?

Thanks that was my thought

Ok got a question do I want to stop my racks at end of RF plate or is it ok to go past the end?

Ok grinding about done and getting close to the fun part. So here are the 2 tanks I'm using to make this. The round one is going to be my CC and the oil take sitting vertically I'm going to cut up for my FB and warming chamber. My plan is to cut along the tape,the bottom is my FB which will be...

Stupid me I was using diameter instead of radius of tank

Ok that's why I want to be double checked. How did you come up with 13? When I ran the numbers it came to an segment area of 217 but when I put 13 in the circle calculator it gave me a segment area of 495. I'm just trying to figure it out for my learning.

Ok so here is my attempt of a drawing of my FB measurements and FB-cc opening.