-
Some of the links on this forum allow SMF, at no cost to you, to earn a small commission when you click through and make a purchase. Let me know if you have any questions about this.
Recent content by dunzee
-
First build-24 gallon patio reverse flow smoker
Thanks for the tip Mike but unfortunately they are galvanized inside and out. Thumbs Up- dunzee
- Post #5
- Forum: Reverse Flow
-
First build-24 gallon patio reverse flow smoker
Turns out my tanks were galvanized, so no go. Back to the drawing board.- dunzee
- Post #2
- Forum: Reverse Flow
-
First build-24 gallon patio reverse flow smoker
Thanks everyone for your wealth of knowledge. Thanks Dave for your calculations. I was able to find two steel tanks we use in the milking industry. They are small (14" diameter x 36" long) giving me 24 gallons. My thoughts were to cut one in half for my FB and that would give me 150% of the...- dunzee
- Thread
- Replies: 5
- Forum: Reverse Flow
-
New member from Ontario Canada
Greetings from Ottawa, Canada eh! I'm still planning my reverse flow smoker build and have started collecting material. I have a mig welder and love to fabricate for my personal use so this build will be a blast. Thanks everyone for your ideas and wealth of knowledge. Dunzee
SmokingMeatForums.com is reader supported and as an Amazon Associate, we may earn commissions from qualifying purchases.
SmokingMeatForums.com is a community of barbecue and outdoor cooking enthusiasts dedicated to smoking meat.
© 2004-2026 SmokingMeatForums.com
