Recent content by Diggerg
-
Some of the links on this forum allow SMF, at no cost to you, to earn a small commission when you click through and make a purchase. Let me know if you have any questions about this.
-
D
Vertical reverse flow insulated build - Advise and wisdom wanted!
Did you fill the tube framework with insulation too?- Diggerg
- Post #15
- Forum: Reverse Flow
-
D
My gravity feed
It's a cut out for my temp controller to sit in- Diggerg
- Post #30
- Forum: Other Builds
-
D
My gravity feed
I used 1"*1/4 lavalock gasket on the cook chamber door and 3/4"*1/8 on the the firebox and chute doors- Diggerg
- Post #27
- Forum: Other Builds
-
D
My gravity feed
It's done! Up and running this weekend. Did a season on Saturday and some baby backs Sunday. Took 45 mins to reach temp of 250.- Diggerg
- Post #24
- Forum: Other Builds
-
D
My gravity feed
Top coat and clear coat done. Blood black pearl.- Diggerg
- Post #23
- Forum: Other Builds
-
D
My gravity feed
2 coats of etch primer and 2 coats of filler primer. Sand this week and then top coat and clear coat.- Diggerg
- Post #22
- Forum: Other Builds
-
D
My gravity feed
All blasted and ready for paint. Flue welded in.- Diggerg
- Post #19
- Forum: Other Builds
-
D
My gravity feed
All done. (Except exhaust and door thermometer to be fitted after blasting). Put all the bits and pieces on to check hole alignment.- Diggerg
- Post #18
- Forum: Other Builds
-
D
My gravity feed
Put the last of the outer plating on today and fitted the chute and firebox door frames- Diggerg
- Post #17
- Forum: Other Builds
-
D
My gravity feed
Few more bits done. Just the outside to plate and the cook chamber door. Then ready for paint- Diggerg
- Post #14
- Forum: Other Builds
-
D
My gravity feed
Got the firebox and transfer tube in and the cuchu tacked in place.- Diggerg
- Post #10
- Forum: Other Builds
