Recent content by devilsmoker

  • Some of the links on this forum allow SMF, at no cost to you, to earn a small commission when you click through and make a purchase. Let me know if you have any questions about this.
  1. devilsmoker

    Use what I got...

    My firebox is below my door. I drilled a 1 inch hole through the block into the fire box. I did this 2 times on the front and one on the side. I welded a washer onto some 3/4 steel pipe that goes into the interior of the box. I will use a magnet that can slide across the washer to limit the...
  2. photo 3-1.JPG

    photo 3-1.JPG

  3. photo 2-1.JPG

    photo 2-1.JPG

  4. photo 1-1.JPG

    photo 1-1.JPG

  5. devilsmoker

    Use what I got...

    I finished up a few weeks ago. .25 steel door. I had to use some angle iron on the back side to get it flat. When the metal supply house sheared it, it put some warp in it.. Handle detail. My welder used an oversized tube to create a bushing. Inside handle stop Found some perfectly...
  6. photo 5.JPG

    photo 5.JPG

  7. photo 4.JPG

    photo 4.JPG

  8. photo 3.JPG

    photo 3.JPG

  9. photo 2.JPG

    photo 2.JPG

  10. photo 1.JPG

    photo 1.JPG

  11. devilsmoker

    Use what I got...

    I got out the sledge and mason chisel. Turned out the top 4 inches was mortar with block scraps down another 5 inches. It went quick once i got a hole started. Felt like an archaeologist when I found an old shirt button in the rubble.. I was able to get it down 9 inches to where it felt...
  12. photo 4-1.JPG

    photo 4-1.JPG

  13. photo 3-1.JPG

    photo 3-1.JPG

  14. photo 5-1.JPG

    photo 5-1.JPG

  15. photo 2-1.JPG

    photo 2-1.JPG

Clicky