-
Some of the links on this forum allow SMF, at no cost to you, to earn a small commission when you click through and make a purchase. Let me know if you have any questions about this.
Recent content by cynthianajones
-
MES trouble code help
The Digikey replacement part has brought this smoker back to life. The ERR1 code is gone. The following chart plots the reading from the control unit vs the actual temperature taken with an infrared thermometer. There is a 30F offset but this is easily overcome: the control unit reads 30F...- cynthianajones
- Post #20
- Forum: Electric Smokers
-
MES trouble code help
ERR1 Error Code is caused by the thermistor indicating too hot a temperature. The thermistor is inside the small metallic tube a few inches from the inside top of the cooking box. I had a 10K ohm potentiometer on hand so I used it to collect some information about the control electronics. After...- cynthianajones
- Post #19
- Forum: Electric Smokers
-
eSmoking has been achieved!
The MES that I am having an issue with has a thermistor resistance of 110 ohms at 60 degrees Fahrenheit. Do you happen to know what the value should be at this temperature, ballpark? I am getting a flashing E11A. I have measured 110 ohms at this temperature.- cynthianajones
- Post #21
- Forum: Electric Smokers
SmokingMeatForums.com is reader supported and as an Amazon Associate, we may earn commissions from qualifying purchases.
SmokingMeatForums.com is a community of barbecue and outdoor cooking enthusiasts dedicated to smoking meat.
© 2004-2026 SmokingMeatForums.com
