Recent content by cpickett
-
Some of the links on this forum allow SMF, at no cost to you, to earn a small commission when you click through and make a purchase. Let me know if you have any questions about this.
-
Exhaust stack question
- cpickett
- Post #10
- Forum: Reverse Flow
-
Exhaust stack question
- cpickett
- Post #9
- Forum: Reverse Flow
-
Exhaust stack question
- cpickett
- Post #8
- Forum: Reverse Flow
-
Exhaust stack question
- cpickett
- Post #7
- Forum: Reverse Flow
-
Exhaust stack question
Thanks Dave, didn't see anything for square rectangle till I re read it.... Must have skimmed over. I say it's 200 gallon because of id plate but it's a little bigger going off of dimensions, probably gunna go 4x9" or 4x10" and going 36" above cc.... But still don't know how far or how to figure...- cpickett
- Post #6
- Forum: Reverse Flow
-
Exhaust stack question
- cpickett
- Album
- Comments: 0
-
Exhaust stack question
Hey y'all, doing my first smoker build, going slow but making some progress.... It is a 200 gallon propane tank, the firebox is 30"wide 30" deep and 24" tall. Due to design flaws (learning experiences) I need to build a rectangular stack, neither Feldons or the alien calculator talk about a...- cpickett
- Thread
- Replies: 9
- Forum: Reverse Flow
-
RF Build just wanted to share
Ok, so you did frame out firebox with angle, was thinking it would be necessary to keep from warping like you say, thanks for the info!- cpickett
- Post #13
- Forum: Reverse Flow
-
RF Build just wanted to share
Ahhh, that makes since, was trying to figure out how it got heat without holes, but that explains it, and you get good heat in there... Thanks, trying to get as much info as I can before I begin my build.... Thanks cody- cpickett
- Post #10
- Forum: Reverse Flow
-
RF Build just wanted to share
Yea I saw the inlets, and was gunna ask what size those are, that's awesome that you have no hot spots! But on your warmer section, above the firebox, it doesn't appear to be connected to the cc and I don't see any holes connecting to fb... Was wondering if I'm looking at that correctly and what...- cpickett
- Post #8
- Forum: Reverse Flow
