Recent content by cadavis7261

  • Some of the links on this forum allow SMF, at no cost to you, to earn a small commission when you click through and make a purchase. Let me know if you have any questions about this.
  1. cadavis7261

    Temperature Control with 18.5 inch WSM

    Thanks for the various suggestions Johnny. I will try these out. I guess I'm a little inpatient thinking after a few smokes that my WSM would be ready to go. I do understand that it is going to require more. The temps did not seem to hold very long. Is it best to leave two of the bottom vents...
  2. cadavis7261

    Temperature Control with 18.5 inch WSM

    I've been trying to maintain a 225 deg temp. The smoker would seem to increase and decrease depending how I set the lower vents. I have a Maverick ET-732 and have checked temp also using a Thermoworks Thermapen. I have only performed a half dozen smokes so far. I suspect from other responses...
  3. cadavis7261

    Temperature Control with 18.5 inch WSM

    I've had numerous issues trying to keep a low temperature on my 18.5 inch WSM. The temp would hold where I want then would start to go up or down. I'd adjust the vents to try and bring it back to where I want it to be. It's be awhile since I have done a smoke due to family medical issues, but my...
  4. cadavis7261

    New 1st Gen Masterbuilt 40 Inch Electric Smoker

    I have never used any kind of torch before. Is there a good brand or particular model that is small. Also, where would the AMPS sit in the MES? The model that I have has the controls and vent on top.
  5. cadavis7261

    New 1st Gen Masterbuilt 40 Inch Electric Smoker

    I have been waiting to post until I could gather some of my initial observations about my new smoker. I do also have an 18.5 inch Weber Smoky Mountain smoker and a 22 inch Weber Performer grill. I live in the Omaha, Nebraska area. I purchased the Masterbuilt smoker because I wanted to be able...
See more
Top Bottom
Back
Clicky