Some of the links on this forum allow SMF, at no cost to you, to earn a small commission when you click through and make a purchase. Let me know if you have any questions about this.
Just a small ultrasonic humidifier. Depending on where it's located and/or the time of year you may need up to both heater, humidifier and dehumidifier.
Currently mine is inside so with 70 degree ambient temps the chamber only has to cool. If it were outside I'd have the need to heat. You just...
I apologise, I cold smoke for an hour at 60-80 degrees. My next target temp is 140, I hold this temp for half hour. After that I crank up the heat to 225-250. This I just how I do it. You could just as easily hot smoke out the door.
Finished smoking, here are the proportions if you'd like to try
pork 25% fat content
Salt 2.5%
Garlic 2%
Paprika 1.5%
Cayenne .2%
Corriander .25%
Cinnamon .15%
Clove .07%
Allspice .15%
Blackpepper .15%
Red Wine Vinegar 1.5%
Water 2%
I cold smoke for an hour at 60-80 degrees. My next target...
I have it inside the house so at the moment I only need a humidifier. I will probably put it out on my back porch this spring. When that happens im sure i will need both as its always shaded and next to a creek. Leaving inside was just easier for the immediate future, also less hardware needed.
im using the Inkbird ITC-608T. It controls the temp and humidity. I am using the fan in the fridge to circulate air for now. Im waiting to see how it works to determine if i need to swap.
I finished my curing chamber and thought i'd share abit on it. It is a whirlpool model et8gtmxkq00. It has freezer on top. Everything was pretty straight forward. First I disconnected the thermostat and light in the fridge compartment. Then using a Dremel cutoff wheel I cut through the plastic...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.