Recent content by blakemcm01

  • Some of the links on this forum allow SMF, at no cost to you, to earn a small commission when you click through and make a purchase. Let me know if you have any questions about this.
  1. blakemcm01

    South georgia

    Got a little more done today. Next weekend I plan on doing the stack and vents and lid stop hopefully. And the drain Pipe and damn for end of the rf plate.
  2. blakemcm01

    South georgia

    Didn’t get much progress done today the weather didn’t hold out. I did get the cc and fb welded together solid, the reverse flow plate cut and welded in, the rack for the cooking grated welded in, and two of the top holes filled and welded. I’m gonna leave the other two open for now and cover...
  3. blakemcm01

    South georgia

    Yea I gotta get a bigger machine from work to fully weld up the firebox to cc don’t wanna push my dads mig that hard. It really isn’t wanting to lay down in the 1/4
  4. blakemcm01

    South georgia

    Thanks for the insight I decided to go with some 5/8 rod bent into some pipe for the hinges. When I laid it out it seems like it should clear the trim. If not I’ll make some taller raised hinges out of some of the 1/4 plate. Got the lid cut and thankfully it kept its shape pretty good
  5. blakemcm01

    South georgia

    Build update After a 2 hour rain delay I got the tank cut open and a lid installed on the fire box. Got the firebox hard tacked to the tank my dads 110 mig just didn’t really wanna do the job and I didn’t want to push his stuff that hard it was wide open wire speed and amps so I’ll get the...
  6. blakemcm01

    South georgia

    On the way to my dads shop to cut the tank open now, and put a top on the firebox.
  7. blakemcm01

    South georgia

    23.625 and 67 long Thanks buddy
  8. blakemcm01

    South georgia

    It has began
  9. blakemcm01

    South georgia

    Cool thanks for the help. What about smoke stack diameter I’m not really understanding the formula from your post to see what I need
  10. blakemcm01

    South georgia

    The tank is 24”. OD And 3/16 wall so I came up with 23.625” id So 11.8125 radius if. All my math is correct Plugging into the calculator Fb/cc opening Area under rf plate And areas at the end of plate was 117.48 And On that note, area under plate I’m confused on that one isn’t that just the...
  11. blakemcm01

    South georgia

    It was a 120 gallon my mistake. And then this taller cylinder was given to me today as well so might as well do a patio smoker and use it to upset the cost of mine
  12. blakemcm01

    South georgia

    I hope to get started this weekend on it I got a 130 gallon tank. I was going to go with a 250 because I can get old propane tanks here from 40-70 dollars depending on the size all day long but this 130 was giving to me. So frees better. But a quick call to the metal shop a 4x8 sheet of 1/4 is...
  13. blakemcm01

    Preciate it

    Preciate it
  14. blakemcm01

    South georgia

    Yea man you ain’t lieing and I’ve only been looking in the RF build section. So I can imagine the information through out the rest of the sight
  15. blakemcm01

    South georgia

    Hey y’all I’ve been reading through for a while on rf builds about to do another one, but this time the right way. There’s a lot of very good information here so I figured I would join and contribute where I could. Blake
See more
Top Bottom
Back
Clicky