Recent content by ARett426
-
Some of the links on this forum allow SMF, at no cost to you, to earn a small commission when you click through and make a purchase. Let me know if you have any questions about this.
-
A
Smoker Design
Thanks. I am looking forward to start welding, but first have to decide the best way to cut the door in the .375 wall pipe. I am thinking I should build the base first to have a better working height.- ARett426
- Post #8
- Forum: Other Builds
-
A
Smoker Design
I am going to make it a standard offset. Should I locate the firebox 1/2 way at the end of the pipe? I located some scrap 3/8 inch plate the other day for the ends and firebox. I have a lot of cutting to do.- ARett426
- Post #6
- Forum: Other Builds
-
A
Smoker Design
At 94.6 pounds per ft the pipe section is heavy, but it was free.- ARett426
- Post #3
- Forum: Other Builds
-
A
Smoker Design
I have a 55 inch length of 24 inch, .375 wall pipe that I want to build a smoker out of. I have looked at Feldon's design page, but I have a few questions: 1) I don't have any 3/8inch plate. Would 5/16 plate be sufficient for the ends, or should I be using 1/2 inch? 2) Based on...- ARett426
- Thread
- design new build new smoker steel firebox thickness
- Replies: 7
- Forum: Other Builds
