or Connect
SmokingMeatForums.com › Forums › Announcements › Roll Call › All info greatly appreciated
New Posts  All Forums:Forum Nav:

All info greatly appreciated

post #1 of 8
Thread Starter 
Hi, I'm Jim and I'm located in Phoenix, Az. Just bought a GOSM and seasoned it today. In the process I noted some potential problems related to ambient air temp.
It was 100 degrees today and seasoning a smoker at 125 was impossible. The ambient in my smoker was 130 before seasoning. I think all went well. Had nice light smoke for the seasoning period. Now my question.
Has anyone put a needle valve on the outlet of the regulator to fine tune the flame. My concern is whether the regulator on the GOSM will be adversely affected if the needle valve puts back ppressure on the regulator.
All that and I ain't smoked a darn thing yet.
post #2 of 8
Welcome Jim -

Sounds like you won't need much fuel there, but cold smoking may be out of the question. You may need an icebox smoker that's still running! Guess your bigest problem will be keeping the heat down out there.

Being from New England I can understand fighting the cold in the winter but this hasn't even occured to me before. It almost sounds like you could just throw chips on the ground and smoke meat.
post #3 of 8
Welcome to SMF! Glad you are here.

I live in the northern part of New York State and have never had a problem keeping the temps in my GOSM down. You want to smoke most meats between 225F and 240F. I also find that the smoker temp will drop when you put cold meat in. If you find you can run it in this range without messing with the valve then all is good. When I seasoned mine here with the gas on low the smoker temps never went below 175F.

Hope this helps.

Take care, have fun, and do good!


post #4 of 8
PDT_Armataz_01_34.gif Welcome to the SMF PDT_Armataz_01_34.gif
post #5 of 8
Welcome aboard SMF, PDT_Armataz_01_34.gif
post #6 of 8
Welcome to SMF. I've seen regulators for turkey friers that have a temp controlled adjustments. Basically a thermostat with the probe on the end that goes into the frier. If you can find one, and if it goes low enough, maybe you could put it on your GOSM to keep temps low. I wish I knew the name of it, but check the Bass Pro website because I know thats where I saw it.
post #7 of 8
Thread Starter 

Info Appreciated

Thanks for the input. I think I'll start small and slow and try a chicken today. I'm sure I'lll have to find some way to further reduce the flame, but thats for another day.
Today is all about the chicken
post #8 of 8
Welcome to the forum. It is a pleasure seeing you here. I hope you will feel free at all times to share, ask questions, and draw from the knowledge found here.
New Posts  All Forums:Forum Nav:
  Return Home
  Back to Forum: Roll Call
SmokingMeatForums.com › Forums › Announcements › Roll Call › All info greatly appreciated