or Connect
SmokingMeatForums.com › Forums › Announcements › Roll Call › 1st UDS Build. Have Questions
New Posts  All Forums:Forum Nav:

1st UDS Build. Have Questions

post #1 of 4
Thread Starter 
Hi everyone. I have a food grade drum with the tan lining. A couple questions regarding this liner...

1 - should I get it sandblasted off?
2 - does it NEED to be removed?
3 - instead of removing the liner, can I spray the inside with the high temp bbq paint that I was going to use on the outside, or is that only if I want my food to taste like paint?

I just spent an hour wire wheeling this barrel, only to be successful in a small area. At this rate, I feel it will take me a day and a half, 50 wheels and cause tendonitis in my shoulder
post #2 of 4
It does need to come off.

Sandblast is the easiest.

Most burn it out then sand the rest out.
post #3 of 4
Yes you need to remove the liner. No you shouldn't paint the inside. I had mine sand blasted inside and out and powder coated the exterior only. Total cost to have the powder coat shop do this was $75. If I had them only sand blast it would have been $25. If you go the sand blast route there is no need to burn out the barrel first.
post #4 of 4

texas.gifHello and welcome from East Texas. This is a great site, lots of information and great people that are willing to throw in their two cents worth on about anything.   



New Posts  All Forums:Forum Nav:
  Return Home
  Back to Forum: Roll Call
SmokingMeatForums.com › Forums › Announcements › Roll Call › 1st UDS Build. Have Questions