or Connect
SmokingMeatForums.com › Forums › Cold Smoking › Info and Practices › Advice on Budget Cold Smoker Build
New Posts  All Forums:Forum Nav:

Advice on Budget Cold Smoker Build

post #1 of 10
Thread Starter 

Hello, I've cold smoked bacon a couple times on my grill using only an AMNPS. I'm hooked! I am looking for a better setup though. My grill has a ton of open areas and the AMNPS either stays lit or completely blows out. I'd like to build a small portable unit that can handle around 20# of pork belly. I'd like it to be mobile and metal. I was thinking something like a cheap brinkman charcoal model? Any thoughts or ideas would be appreciated. Thanks.

post #2 of 10
Thread Starter 

Any thoughts?

post #3 of 10

I've seen pictures of guys cold smoking in a cardboard box.

 

You basically just need a box with a roof.  Just sturdy enough to hold together

 

A thin wood (1x2's) frame that screws apart.  Cheap plywood for sides & top.  You will need supports where ever you plan on placing racks or hangers.

You could also use foamboard insulation for the sides & top.  It may help keep some heat in on really cold days.

 

Vents in the bottom.  Bigger vents in the top.

 

Don

post #4 of 10

What are you wanting to spend? Spent about 100 bucks on plywood and studs. Had cedar for trim and bought hinges and such.

post #5 of 10
Thread Starter 
Looks good Dave. I like both ideas. I'm ok with spending in the $100 range. My only issue is I need something about the size of an MES that is easy to move on a patio then through my yard to store. Has anyone ever repurposed a brinkman smoker or made one out of a small steel drum, say 30 gallons?
post #6 of 10

 This is what I did.  4" casters underneath for mobility.  Got it for $150 because the the heating elements went bad. This equipment is expensive to repair $200 x 3 for the elements so they scrap them.  If you want a hot smoker add  a stove burner in the bottom buy  a temperature control (PID) and their you go. I have a 40# smoker for under $500.

post #7 of 10
Yup.. a really big cardboard box works great.... get some stackable cooling racks to put in it... cut some air vents in it.... everything folds up for easy storage....
post #8 of 10
Thread Starter 

I like the idea of using an old metal smoker. I would like to be able to just set it back by my wood pile and move it to the patio when I'm ready to smoke. Has anyone tried this with a cheap Brinkman smoker?

post #9 of 10

Look around. I did find a verticle charcoal smoker at a garage sale for 20 bucks.  Yard tall and 14"x14". 3 racks plus water pan which can be replaced with another rack. Cold smoked alot of peppers and  cheese once. Have done smoked chicken thighs in it couple times. and did great on temp hold. Just look around.

post #10 of 10

Here's an Idea for ya and will not cost ya an arm and leg either. 

I cold smoke in my Master Forge I bought from Lowes. they run 150-175 range depending on if you catch them on sale.

http://www.lowes.com/pd_411913-95393-MFX784BDP_0__?productId=4459479&Ntt=smokers&pl=1&currentURL=%3FNtt%3Dsmokers&facetInfo=

I think this will fit what you re looking for. 

New Posts  All Forums:Forum Nav:
  Return Home
  Back to Forum: Info and Practices
SmokingMeatForums.com › Forums › Cold Smoking › Info and Practices › Advice on Budget Cold Smoker Build