Toggle sidebar

Epoxy polyester powder coating in smoke box

  • Some of the links on this forum allow SMF, at no cost to you, to earn a small commission when you click through and make a purchase. Let me know if you have any questions about this.
SmokingMeatForums.com is reader supported and as an Amazon Associate, we may earn commissions from qualifying purchases.
kingmind1

kingmind1

Newbie
Original poster
Jan 17, 2017
1
10
I'm trying to build a smoker out of an old steel cabinet. Found the spec online and it is coated w epoxy/polyester powder. Any suggestions on removal or can I isulate over it?
 
You must log in or register to reply here.
SmokingMeatForums.com is reader supported and as an Amazon Associate, we may earn commissions from qualifying purchases.

Similar threads

seenred
Hasty Bake Legacy 131 Has Arrived!
Replies
33
Views
13K
Charcoal Smokers
seenred
seenred
seenred
Red's Next Build Project?
Replies
38
Views
4K
Smoker Builds
seenred
seenred
paleoman
Get In My Belly!
Replies
17
Views
8K
Hot Smoked Bacon
paleoman
paleoman
B
First Brisket Nerves
Replies
17
Views
25K
Blowing Smoke Around the Smoker.
philpom
philpom
R
My Journey
Replies
2
Views
869
Wood Smokers
Jim_C
Jim_C
paleoman
Bacon... Here we go again...
Replies
6
Views
6K
Hot Smoked Bacon
paleoman
paleoman
A
First smoker build need some guidance
Replies
9
Views
1K
Smoker Builds
A.Strybel
A
tombigbee
To continue beating the poor horse.......
Replies
13
Views
6K
General Discussion
schlotz
schlotz

Latest posts

Hot Threads

Top Bottom
Back
Clicky