Toggle sidebar

Search results

  • Some of the links on this forum allow SMF, at no cost to you, to earn a small commission when you click through and make a purchase. Let me know if you have any questions about this.
  1. senorkevin

    Smoker frame

    I think I am also missing a plate to place above the heat source.
  2. senorkevin

    Smoker frame

     Here is what I have planned so far. I was planing on welding the bottom plate to the box section. Now however, I think I need to re-design to allow for the air flow. I will be using a propane burner but still want to use charcoal once in a while. I also plan on drilling a hole to allow for cold...
  3. Frame inches.jpg

    Frame inches.jpg

    • senorkevin
    • Media item
    • Comments: 0
    • Album: Smoker frame
  4. senorkevin

    Smoker frame

    So below the heat and above the food?
  5. senorkevin

    Smoker frame

    Should the holes be below/above or level with heat source and food level?
  6. senorkevin

    Smoker frame

    Here is a pic of the door frame. The 17" at the bottom is roughly the heat source (gas burner) level. The 17" at the very top is the line with I will hang from. The second 17" from top is the highest rack level. Where abouts should I drill the holes for the air flow? I plan on having a slide...
  7. Door frame.jpg

    Door frame.jpg

    • senorkevin
    • Media item
    • Comments: 0
    • Album: Smoker frame
  8. senorkevin

    Electric food slicer with metal gears?

    Does anyone know of an electric food slicer with metal gears (not nylon) for around $100-150?
  9. senorkevin

    Gas Smoker Heating Assembly

    Would you recommend this...? http://www.sausagemaker.com/49900gassmokerheatingassembly.aspx
  10. senorkevin

    Smoker frame

    Sometimes, everyone is a comic!!!! It is called Canel unistrut or unicanal. Now we can sleep well know what it is called!! (English humor!)
  11. senorkevin

    Smoker frame

    That's a sweet idea! Thank you. I'll keep a look out for sure. Don't suppose anyone knows what it is called in Spanish???
  12. senorkevin

    Cooking racks info needed

    Im thinking on these... I hope these will be ok to use.
  13. senorkevin

    Smoker frame

    I'm not sure about about self tapping screws. However, I was thinking about tapping where possible. Less holes the better!
  14. senorkevin

    Smoker frame

    Here is the plan so far... I might change the rack supports to angle iron and bolt them to the sides of the smoker. Please feel free and add comments suggestions.
  15. Smoker frame

    Smoker frame

  16. steel smoker 2.jpg

    steel smoker 2.jpg

    • senorkevin
    • Media item
    • Comments: 0
    • Album: Smoker frame
  17. senorkevin

    Cooking racks info needed

    Not here in Mexico. Everything is worth something!!
  18. senorkevin

    Smoker frame

    I am planning on using 1.5 inch box and 1/8 grade steel plate. The panels will also be bolted to the frame so is doesn't bow. I might even bolt the shelf supports to the plate. I'll seal it with high temp non toxic silicon or silicon cement. I'll try a post a frame design later.
  19. senorkevin

    Smoker frame

    Could you please share your wisdom?
  20. senorkevin

    Smoker frame

    Is it possible to make a frame from box section without any welds, only nuts and bolts?
Top Bottom
Back
Clicky