Some of the links on this forum allow SMF, at no cost to you, to earn a small commission when you click through and make a purchase. Let me know if you have any questions about this.
My results so far have been great tasting, but today's cook was pretty frustrating.
I started off with pre-heating the smoker to 230.
Two pork buts, about 13.5 lbs total.
Ambient temp was 43°. Meat temp was 43°.
Water tray full of boiling water.
Lit the chip tray with matches.
Closed the...
Video shows the TA4, mine is the TD4. Difference is that the TD4 has a manual mode & the TA4 does not.
If you get on of them know that the wiring diagram is wrong.... the polarity for the DC out to the SSR is reversed.
-k
Thanks for the suggestions! I will try to document my procedures.
I wanted to get smoking today so I removed the stock thermometer probe from the door and drilled out the hole big enough for the PID probe. It is about 2/3rds up from the element. I have a pork but & some pork belly in there now...
Hi all, I am new here so go easy on me. ;). I have the Smoke hollow electric & have just built a PID controller to use with it.
I was thinking of inserting the temp probe about halfway up the side, a little above the handle to get an accurate reading near the middle of the box. The probe is...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.