Toggle sidebar

Search results

  • Some of the links on this forum allow SMF, at no cost to you, to earn a small commission when you click through and make a purchase. Let me know if you have any questions about this.
  1. pete mazz

    Pork Roll (Taylor)

    Try cubing it and smoking. One of my favs.
  2. pete mazz

    Ready to throw in the towel on my Masterbuilt 40" Propane Smoker.

    I built my smoker. It doesn't have a control knob, just the regulator and needle valve connected to a turkey fryer pipe burner. With the needle valve wide open I set the regulator to get the burner running pretty high and use the needle valve after that . It likes to run ~250 comfortably which...
  3. pete mazz

    Ready to throw in the towel on my Masterbuilt 40" Propane Smoker.

    Lowest I run on gas is 225. I have an electric element installed for col smoking . The needle valve allows for finer control of temps.
  4. pete mazz

    Ready to throw in the towel on my Masterbuilt 40" Propane Smoker.

    The HP regulator is set to adjust my burner to high with the needle valve wide open. Turning down the needle valve gives fine control of the gas flow .
  5. pete mazz

    Gotta heating element question. Help needed.

  6. pete mazz

    Another 80 Gallon Air Tank

    http://planetcalc.com/6097/
  7. pete mazz

    Gotta heating element question. Help needed.

    Unless it's very well insulated you'd need ~5000W to reach anywhere near that temp. 1W = 3.4btu and 1.5btu per cubic inch would be minimum
  8. pete mazz

    importance of chimney length (height) ?

    Sorry. All the talk about UDS's got me.
  9. pete mazz

    importance of chimney length (height) ?

    On any vertical smoker the CC acts as the chimney so all that's needed is an exhaust .
  10. pete mazz

    First smoker build need help,60 gallon air tank

    The drawing on the calc is looking at the smoker from the top. Enter the throat area (FB to CC) given by whatever smoker calc you used, cut a piece of cardboard or something the same width as your BP and lay it in the CC to measure the bell end depth at that height. Then enter the BP width and...
  11. pete mazz

    First smoker build need help,60 gallon air tank

    http://planetcalc.com/5966/
  12. pete mazz

    Question about cc and fb opening

    http://planetcalc.com/5155/
  13. pete mazz

    100# LP tank RF build -in early planning stages

    http://planetcalc.com/5185/
  14. pete mazz

    First Build 20" Offset

  15. pete mazz

    Another 80 Gallon Air Tank

    Feldon's recommends a half circle with that diameter. Here's some other options. http://planetcalc.com/5155/
  16. pete mazz

    Need Help w/ figuring out RF Fuel Tank Smoker/Cooker build

    Throat seems way too small
  17. pete mazz

    1st smoker build - 140 gallon

  18. pete mazz

    1st smoker build - 140 gallon

    Try my calculator for the throat opening. http://planetcalc.com/5155/
  19. pete mazz

    Can ABT's be prepped early?

    I freeze them and put them on frozen. That gives more time for the bacon to crisp and the filling doesn't ooze out.
  20. pete mazz

    fire box opening.

    Try this:
Top Bottom
Back
Clicky