Follow along with the video below to see how to install our site as a web app on your home screen.
Note: This feature currently requires accessing the site using the built-in Safari browser.
Recent content by thedude99
Some of the links on this forum allow SMF, at no cost to you, to earn a small commission when you click through and make a purchase. Let me know if you have any questions about this.
I’ve heard this, ease of burning a clean fire is probably the explanation.
If you know how to run your small offset properly, I highly doubt there is going to be a noticeable difference. If there is, it’s likely to be very small.
The Workhorse is designed for even temperature’s across the grates without the need for tuning plates like the LSG needs. To me - this is a better design.
Folks over on the bbq-brethren form have reported actually getting a 5 degree differential across the pit as well.
Cook chamber is 20”x36” - 975 square inches.
I don’t cook much more than a brisket or two, a couple of pork shoulders or a few racks of ribs with it. I could fit a good deal more on.
The specs are here http://www.horizonbbqsmokers.com/backyard-smokers-1/20-classic-smoker
Horizon puts the weight of a lot of their smokers on their website, and the one a size down from the one that looks similar to this one is listed at 900lb on the pallet. It’s a lot smaller.
http://www.horizonbbqsmokers.com/backyard-smokers-1/30-rd-special-marshal-smoker
The propane hookup is probably for getting the fire started. That’s a pretty common accessory for stickburners.
As far as the size, it really depends on what you are cooking. Future capacity is certainly important, but if most of your cooking is going to be a couple of briskets or a few racks...
Do you need a smoker that big? Price is likely pretty good if you do, but I don’t know your market.
Old OKJ’s are supposed to be very good. It would be made in America from heavy duty steel. Fully welded. Not assemble your own thin steel like current OKJ’s
I have a Horizon Smoker, it’s very...
Try using smaller splits, and adding them more frequently.
Cheap offset smokers are a battle - it likely doesn’t have good airflow.
Mad Scientist BBQ just put out a video about running on a smoker like yours - might be worth a watch.
Learn to ride the temperature differences. Your bbq will be fine.
I have the same smoker. It runs happily between 250-275 as a general range. Which means I end up cooking between ~ 250 to 300 (not as a consistent temp - my cooks go through the range of 250-300)
It’s a lot of work (and...
I always had to run that smoker with the door wide open. Anytime I tried to close it and control the temps with the vent my split would start to smolder.
The vent is undersized IMHO
I think it comes down to poor airflow in those smokers.
I had the same problem with my OKJ Highland, with properly seasoned wood. Smoker was sealed, happened with small splits
I upgraded to a Horizon, and the problem went away. Same wood pile.
I wouldn’t bother upgrading to an Oklahoma Joe. It would be a bit better than what you have, it you will still battle all the cheap offset smoker issues with it.
I had an OKJ Highland for a while. I turned out great BBQ with it, but it was a constant battle with it.
I upgraded to a Horizon...
Thanks folks. It came out of the cooler fine after 4 hours. Definitely continued to cook a bit, and it wasn't as good as if it had come straight off and rested. But it was still quite good.
It caught me off guard, it was an 18.5lb bird and was done in around 4 hours. It was unstuffed, the...
Hi,
My bird was done sooner than expected. I've foiled it, wrapped it in towels and put it in a cooler. From a food safety point - how long can I leave it sit? Is 4 hours too long?
Thanks!