Recent content by svaillan
-
Some of the links on this forum allow SMF, at no cost to you, to earn a small commission when you click through and make a purchase. Let me know if you have any questions about this.
-
Math and FB to CB deminsions
Hello all. Here is what I have so far for math. 124gal Tank 24 1/4" wide 12 1/8" Radius (or 12.125) Cooker Chamber Size 28644.00 Recommended Firebox Size 9548.00 Recommended Chimney Volume 494.00 Recommended Air Inlet Area 29.64 Recommended Firebox-to-Cooker Opening Area 79.04 I tried using...- svaillan
- Thread
- Replies: 7
- Forum: Reverse Flow
-
Firebox question
Weird question........When looking at the firebox volume size. Does any area below a fire grate that is used for ash clean out count toward that volume. Or is it not considered? Thanks as Always Steve- svaillan
- Thread
- Replies: 1
- Forum: Reverse Flow
-
Door positioning???
Thanks guys!!! I really appreciate all the help and advice. I'll work up numbers and share them on a new post asking for a "second set of eyes" :) I think I'll get the numbers figured out, build the firebox and then cut the firebox notch first. Thx all- svaillan
- Post #9
- Forum: Reverse Flow
-
Door positioning???
Thanks for all the info. The problem is I do need to cut the door first. I am just a hobby welder and will be having a local shop do the work off of my supplied design. But they won't take it without the door cut. They're scared :) If I do go ahead and cut the firebox notch. How do I determine...- svaillan
- Post #4
- Forum: Reverse Flow
-
Door positioning???
Hello everyone. I am starting my first build with an 125gal horizontal tank. Actually the tank tag says 124gal. Anyways I did some searching and I cant find any information on door cutting position. Should the top of the door cut be cut at center or below center of the tank? And if the top of...- svaillan
- Thread
- Replies: 9
- Forum: Reverse Flow
