Toggle sidebar

Recent content by stansdad24

  • Some of the links on this forum allow SMF, at no cost to you, to earn a small commission when you click through and make a purchase. Let me know if you have any questions about this.
  1. stansdad24

    Question about Masterbuilt Gas Smokehouse

    So you ditched the supplied chip tray altogether? That makes sense, thanks!
  2. stansdad24

    Question about Masterbuilt Gas Smokehouse

    Are there any other tricks to using the chunks in this smoker? I usually use chips but I wanted to try chunks. Have the exact same cake pans and the chunks either weren't smoking or the temps were way to high (290+). I couldn't seem to find much of a balance.
  3. stansdad24

    New to smoking -- from S.W. Michigan

    Thanks for the warm welcome!
  4. stansdad24

    New to smoking -- from S.W. Michigan

    Thanks for the warm welcome! The I.T. was 180, which I have found out after the fact is too low. A remote thermometer is on my wish list, appreciate the recommendation. Wasn't aware of the wrap & rest part. I let it rest but it wasn't wrapped. Again, thanks for the advice.. :) What temp...
  5. stansdad24

    New to smoking -- from S.W. Michigan

    Thanks for the warm welcome guys. Signed up for the eCourse as recommended, definitly a good resource! So, round one is in the books and the best word I can use to describe the outcome would be...... edible. lol Shoulder looked the part but wasn't near as tender as I would have liked. My...
  6. stansdad24

    New to smoking -- from S.W. Michigan

    Hello all, Brandt here from S.W. Michigan. Wife dropped off as new Masterbuilt vertical gas smoke house. Been wanting a smoker for years so needless to say I am still smiling. First stop after assembly was google which led me here. What an awesome resource! I am absolutely brand new to smoking...
See more
Top Bottom
Back
Clicky